After 2 years of waiting, the license plates (or more accurately, the registration plates) of our EcoSport have finally arrived (you can check availability of plates in the LTO website).
In this video, I have discussed how I installed the front and rear license plates using a theft-deterrent type of screw called security screws. Security screws are no longer supplied with the plates, thus, must be purchased separately (you can buy 4 stainless-steel security screws complete with nut and washer for 100 pesos or 2 US dollars). Installing the plates with security screws requires some effort since you need to drill through the plastic material then place and tighten a nut on the other side.
To watch the video on how I installed the front and rear license plates in our EcoSport, head directly to Installing License Plates in an EcoSport.
Related link: Installing the LTO RFID Sticker
To view all EcoSport tutorial videos, click here.
To subscribe and receive posts about our beloved EcoSport, click here.
ECOSPORT DIY SERIES
Isa na namang kaalaman sa ating minamahal na EcoSport
© Anthony Urbano (Manila, Philippines)
ECOSPORT DIY SERIES 
Hi Sir Anthony! Magandang araw po.
I watched your vlog regarding the installation of lto license plates. I recently got mine and installed the front plate only. I am having a hard time to figure out how to install the license plate in the rear part of ecosport. Appreciate your assistance on this sir. More power and thank you
LikeLike
There is a plastic cover that you will need to remove (e.g. using a soldering iron). You just need to cut an access hole to allow you to place a washer and a nut, and use a wrench to tighten the nut. The alternative is to remove the bumper, then install the plate. For obvious reasons, I did not show everything on video :)
LikeLike
Good eve, sir san po kayo nakabili ng screw?
LikeLike
Meron rin yan kahit saang hardware.
LikeLike
Saan po makabili ng bolt and nuts ng ecosports sirl
LikeLike
Saan po makabili ng bolt and nuts ng ecosports sirl
LikeLike